If you're shopping for control cables connectors io, the two Belden reels in front of you look alike but force a real trade-off: conductor thickness versus cost. The price spread between them is substantial, and the shorter reel carries more wires. That's a classic decision point.
Quick verdict: If the project calls for a multi-conductor cable with thicker wire, the Belden-CH 580479 is the right call. For a longer, less expensive alternative, the Belden 2AS-1801POS gets the job done.
| Feature | Belden-CH 580479 | Belden 2AS-1801POS |
|---|---|---|
| Price | $1,199.99 | $641.24 |
| Wire gauge | 14 AWG | 18 AWG |
| Length | 475 ft | 482 ft |
| Condition | New - Open box | New - Open box |
Where the Belden-CH 580479 wins
The 14 AWG conductors and 12-wire design are its biggest advantages. With a dozen wires in one jacket, you can pull a complete control circuit in a single run, and the thicker gauge gives you more headroom for longer distances or higher loads. The 475 ft of cable is enough for most cabinet-to-machine runs, and the 12-wire layout means less bundling and fewer pull points.
Where the Belden 2AS-1801POS wins
The 18 AWG reel comes in at $641.24, which is $558.75 less than the 580479, and it stretches to 482 ft. It also carries clear ratings: 600V TC, 150V NPLF, and 90C dry/wet. Those numbers take the guesswork out of spec'ing the cable for a particular environment. If your control wiring doesn't require that much thickness, this cable gives you more length for a significantly lower price.
Belden-CH 580479 475Ft 14 AWG 12 Wire
The Belden-CH 580479 is the heavier-duty option in this comparison. The listing warns it may show shelf wear and has no box, so be prepared for a reel that's been handled. The jacket may have scuffs, but the functional performance is what you're after. On the upside, the conductor layout is the reason to consider it: a dozen individually insulated wires in one jacket greatly simplifies routing a full control circuit. For a project that needs many signals in a single pull, this reel delivers. The thicker conductor size is the key advantage if you're running cables over longer distances or through areas where a thinner wire would drop too much voltage. If you need that capacity, the higher price is justified.
Belden 2AS-1801POS-B-B/R 482Ft 18 AWG
The Belden 2AS-1801POS is the more economical reel for lighter control circuits. Its ratings are clearly displayed: 600V TC, 150V NPLF, and 90C dry/wet, so you know where it's suited. The 600V rating means it can handle typical industrial voltages, while the dry/wet 90C rating tells you it tolerates heat and moisture. The thinner wire means it's not for high-current runs, but for standard control applications it's a solid choice. Just be sure to check the reel for any marks when it arrives, since these reels can show handling signs. The lower price and extra length make it a practical pick for routine control wiring, especially when the circuit doesn't demand a thick conductor.
Final choice by use case
Choose the Belden-CH 580479 when you need the conductor count and the heavier gauge. Choose the Belden 2AS-1801POS when your circuits are lighter and you value the lower price and added length. Both are new open-box Belden reels; the deciding factor is your specific wiring needs.
